Camera Kit OE fit, with Gentex® Mirror fits 2010-2013 Tundra®

2010-2013 Tundra® - Select the desired handle configuration from the box above when ordering. 

NOTE:  Not all 2012-2013 Tundras® are pre-wired for camera from the factory.  The factory camera connector will always be on the rear frame rail but there can be a missing intermediate harness that prevents the camera signal from reaching the overhead console connector.  To be certain you are prewired you will need to run a continuity test between the 4 wires in the rear camera connector and the connector behind the overhead center console.  If you do not get continuity order the full harness version of this kit from our online catalog.

If you purchase just the camera module you will install our camera module into your camera-ready handle using the included bolts, route the harness through the bottom of tailgate and plug in on the frame rail.  This will only bolt into a factory or aftermarket handle with the OEM camera opening.  You cannot drill a hole and make this system work.

If you purchase in a handle simply replace your existing tailgate handle with this handle containing the integrated backup camera. Two 10mm bolts hold your handle in place, swap the lock, fish the camera wire through the tailgate, plug in to your chassis, and reassemble. The entire camera installation process can take less than 20 minutes. 

Replace your factory mirror with the included Gentex® mirror by removing the upper center console, remove the old mirror, swap with the new mirror, plug into the existing harness, and reassemble! - another 15-20 minutes. 

NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.