Rear Surface Mounted Backup Camera
High grade, rear surface mount option
Camera is FMVSS 111 compliant! Adding a backup camera to ANY car or truck could never be simpler!
This universal camera is surface mounted so it will require a flat section approximately 1" x 1" for mounting. Drill a small hole and run the cable through to the full chassis harness that will run to your aftermarket display or separate video monitor.
Kit includes the following:
- Black or Chrome plated rear facing surface mount camera with our latest super CMOS camera - the latest camera technology!
- Mounting hardware
- 25 foot wire harness
- Installation instructions
- 3 year limited camera warranty
Camera Specifications:
- Super CMOS chip - outstanding color, contrast, and clarity!
- Removable parking guidelines
- 170 degree view
- 600 TV lines of resolution
- .1 lux minimum illumination - Outstanding night vision!
| SKU | CS-RSM |
|---|---|
| Video System | NTSC |
| Vehicle Interface | Not Included |
| Waterproof/Dustproof Level | IP 67 |
| Night Vision | < .2 Lux |
| Power Supply | 12 Volts |
| System Manufacturer | EVI Systems |
| Camera Resolution | 600 TVL |
| Parking Guidelines | Selectable on/off |
| Camera Orientation | Rear Facing |
| Fit Type | Universal fit |
| Connection | Aftermarket Display (RCA) |
| Sensor Type | Super CMOS |
| Sensor Brand | EVI Systems |
| Viewing Angle | 170 Degrees |
| Warranty | 3 Year |
| Camera Type | Rear Camera |
| Vehicle Category | Car, Truck, Universal |
| Number of Cameras | 1 |
| Reason for Shopping | Adding the camera(s) |
| Wiring Type | Hard Wired |
| Camera Mount Location | Universal Mount |
| For a monitor it uses | Your aftermarket display (RCA) |
Requires a flat section approximately 1" x 1" for mounting. Connects to any aftermarket radio or can be connected to several different factory radios using an interface module. (not included) Requires a 12 volt power source.
Requires a flat section approximately 1" x 1" for mounting. Drill a small hole and run the harness through. The RCA cable will run inside the vehicle to your monitor and you will need a reverse activated 12v power source and ground wire.
Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring! See related item SKU: CS-RPW-P
NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.
Related Products
10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount 10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount