3rd Brake Light Camera for Trucks with Aftermarket Radio, Fits 2019-2022 RAM®
Add a cargo camera to an aftermarket radio or separate display!
This is an add-on trim bezel that mounts to your factory third brake light and adds the rear camera convenience to the top of your cab! Now you can see your fifth wheel or anything else that is inside your bed without having to have a spotter guiding you for trailer connections etc. Adds a trim bezel with premounted camera to your factory third light assembly and the camera connects to an aftermarket radio or separate display.
Comes with parking guideline options, meaning that the guidelines can be turned off.
*Not compatible with factory radio display.
Kit includes:
- Adjustable camera pre-mounted in RAM 3rd brake light bezel with harness
- Detailed installation instructions
- 3 year limited warranty
Camera Specifications:
- Super CMOS sensor for ultra clear display
- Resolution: 600 TV lines
- Minimum Illumination: 0.2 Lux
- View Angle: 170
- Video Output: Full color video
- Working Voltage: DC 9-16V
- Parking Line: On/Off selectable
- Image: Mirror/Non mirror selectable
- Adjustable tilt to obtain the best view!
- Waterproof: IP67
- 25 foot harness
This kit allows you to see what is in the bed of the truck! This camera comes with a 3 year warranty and professional installation is recommended.
| SKU | CS-19DTR3L |
|---|---|
| Cam Only/Complete Kit | Cam Only |
| Video System | NTSC |
| Vehicle Interface | Not Included |
| Waterproof/Dustproof Level | IP 67 |
| Night Vision | .1 Lux |
| Power Supply | 12 Volts |
| System Manufacturer | EVI Systems |
| Camera Resolution | 600 TVL |
| Parking Guidelines | Yes |
| Connection | Aftermarket Display (RCA) |
| Sensor Type | Super CMOS |
| Viewing Angle | 170 Degrees |
| Warranty | 3 Year |
| Camera Type | Cargo/3rd Brake Light camera |
| Vehicle Category | Truck |
| Number of Cameras | 1 |
| Reason for Shopping | Adding the camera(s) |
| Wiring Type | Hard Wired |
| Camera Mount Location | Factory 3rd Brake Light |
| For a monitor it uses | Your aftermarket display (RCA) |
| Make | RAM |
| Model | 1500,HD |
| Year | 2019,2020,2021,2022 |
| Make Filter | Ram |
| Model Filter | 1500, HD |
| Year Filter | 2019, 2020, 2021, 2022 |
Factory 3rd brake light should measure approximately 16 inches for this to fit. If your 3rd brake light is 14 inches see SKU: CS-DTR3L
Compatible with 2019-2022 RAM® trucks with aftermarket radio or separate monitor.
*Not compatible with factory radio display. See SKU: CS-19DTR3L-VI
Remove your factory 3rd brake light and install the trim bezel from this kit, then reinstall your factory light.
Connect camera cable to the main harness. Run the harness to the inside of the vehicle to your display.
Locate a 12 volt accessory power source for power and ground to a clean piece of metal on the frame. Connect the male RCA to the female RCA on your display monitor
We recommend using our CS-RPW-P power module to ensure adequate power for the camera.
NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.
Related Products
10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount 10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount