Plug & Play Replacement Camera fits 2010-2017 Tundra
Replaces burned out Tundra camera!
Finally an affordable solution to replacing your burned out factory Tundra camera!
This is a plug and play replacement module for your factory camera on 2010-2017 Toyota® Tundra series pickup trucks. Simply remove your old camera module from the bezel and replace with this new module! Installation time is less than 15 minutes and save $$$ over a factory replacement module that is priced at over $800!
- Camera module only - does not come with a handle. Camera will mount into your existing handle.
- Camera module premounted in OEM Toyota handle. This option uses a factory Toyota® handle and is completely assembled and ready to install
- Camera module premounted in aftermarket handle. This option is the same as above but in an aftermarket Tundra handle with camera opening
NOTE: This is a 6 volt camera and is designed to replace an existing Tundra camera. Toyota® navigation units and mirrors produce 6 volts to the camera output and require this camera as it is a compatible CMOS that runs on 6 volts. If your Tundra didn't come with a camera and are looking to add one see our complete lineup of 12 volt Tundra camera kits!
Camera specifications:
- Super CMOS 6v sensor - ultra clear picture and color contrast
- <.2 LUX night vision
- 600 TVL of resolution
- Factory parking guidelines - optional turn on and off at the harness
- Requires 6 volt input
- 2010-2017 plug and play OEM Toyota® harness included
- 3 year warranty!
SKU | CS-10TUNOEM-M |
---|---|
Video System | NTSC |
Waterproof/Dustproof Level | IP 67 |
Night Vision | < .2 Lux |
Power Supply | 6 Volts |
System Manufacturer | EVI Systems |
Camera Resolution | 600 TVL |
Parking Guidelines | Selectable on/off |
Camera Orientation | Rear Facing |
Connection | Factory Connector |
Sensor Type | Super CMOS |
Viewing Angle | 170 Degrees |
Warranty | 3 Year |
Camera Type | Rear Camera |
Vehicle Category | Truck |
Number of Cameras | 1 |
Reason for Shopping | Factory camera failed/need replacement |
Wiring Type | Factory Plug&Play |
Camera Mount Location | Factory Tailgate |
For a monitor it uses | Your factory display |
Make | Toyota |
Model | Tundra |
Year | 2010,2011,2012,2013,2014,2015,2016,2017 |
Make Filter | Toyota |
Model Filter | Tundra |
Year Filter | 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 |
2010-2017 Toyota® Tundra with existing backup camera.
Remove the torx screws on the back side of the tailgate, remove the two bolts holding your factory camera to the bezel, unplug the factory camera from the harness. To replace simply reverse the order - 15 minutes to install!
Q: Where does this camera plug in?
A: This camera plugs directly into your factory camera harness under the truck, behind the rear bumper, on the passenger side frame rail. It does not plug in at the tailgate harness near the camera. That harness will no longer be used.
NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.
10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount